Failed to initialize the NVIDIA kernel module!

[INERG]

hi
i have this error when i startx :(

i have a geforce 4 64mb with tvout and dvi from point of view => http://www.pointofview-online.com/products/obsolete/ti4200.php
i have installed the driver without any problem
load it with modprobe nvidia
I checked with 'lsmod' if the module was correctly loaded
Module Size Used by Tainted: P
nvidia 1545440 0 (unused)

I have that error after launching startx :(

If someone can help me, it would be kind.:)

my XF86Config (http://believer.homelinux.org/pom/XF86Config) and XFree86.0.log (http://believer.homelinux.org/pom/XFree86.0.log) and startx -- verbose 5 (http://believer.homelinux.org/pom/XFree86.1.log)

driver 1.0-4349
distrib slacware 9
bios: 4.25.00.30.00
cpu amd xp 1800+
motherboard ecs k7s5a
Monitor Valiance dt-1536d (max 1024*768 horizontal: 30-54 khz and vertival 50-120hz)

[zedro]

i've gotten that very same error about a million times trying to set up my dual monitors with twinview... usually it is when my XF86Config-4 is set up wrong... i just reinstall the drivers and everything is fine... i was running it on mandrake 9.0 and 9.1 though... so i dont know if this will help or not

but good luck anyway

[bwkaz]

Is there anything helpful in the output of dmesg, near the end?

Does turning PnP OS off, or turning Assign IRQ to VGA on (both of these settings are in your BIOS), help?

[INERG]

big thx bwkaz :)
i turn irq to vga and now it's work :)
i can use the driver nvidia :)
big big big thx ;)
lol