Help me push my system a little more

[tjohn]

Ok, I'm fine bumping the Q6600 up to 333 fsb and ram up to 1002, every else on auto. I bump the fsb to 345 it auto clocks the ram to 1032 and that runs stable. Once I go 355 fsb the ram goes to like 1064 and no post. I clock the ram down to the next lowest whatever that was and post but not stable. Noob question but, what do I need to do? Volts are all on auto.

[XDanger]

auto might be bad ,set all the correct numbers whatever they may be ,Probably needs more Voltage all over the shop.

Find someone with your specs and a decent oc and set the voltages a bit lower than them to test if you want a risky shortcut.

Is this p5e3 deluxe article relevant to the P5E's bios ,It looks nice.

[tjohn]

Thanks butt I'm still confused :(

[xmichaeluk]

It's pretty much a trial and improvement process, bump up the vcore voltage a little bit at a time and check if your PC is stable. I would either use Everest stability test or Prime95 to test your cpu.