Trying for 1:1 ratio at 1600fsb

[Quick420]

I'm a little confused about how to correctly achieve a 1:1 ratio with my board,it's an Asus P5N-D.I set it to 1:1 ratio and unlinked but the 1:1 goes back to auto when I do that.I'm using ddr2/800mhz ram.Does anyone have this or a similar board?Im trying for 3600mhz at 1:1 ratio.Will keep trying myself for a while.....;)

[Quick420]

I guess it must be at 1:1 ratio already,thats what cpu-z says.Even though in the bios it's set to auto,if I switch it to 1:1 it goes right back to auto.Whateva thnx for all the pointers though:thumbdwn:

[CaptNKILL]

Whateva thnx for all the pointers though:thumbdwn:

This is the least active forum you could have posted this in. I for one never saw this thread until now...

[Quick420]

Sorry I was a wee cranky when I posted that stupid comment,no harm done;)

[XDanger]

Sorry I was a wee cranky when I posted that stupid comment,no harm done;)

http://bp2.blogger.com/_0_1jH0TaDjU/RkbmWtB8pcI/AAAAAAAAAqk/XnJqe186D_I/s400/jimmyk.jpg

[Quick420]

http://bp2.blogger.com/_0_1jH0TaDjU/RkbmWtB8pcI/AAAAAAAAAqk/XnJqe186D_I/s400/jimmyk.jpg

Lawls ...........weird looking peeps fer sure:afro:

[XDanger]

Thats his wife.

[Dazz]

I guess it must be at 1:1 ratio already,thats what cpu-z says.Even though in the bios it's set to auto,if I switch it to 1:1 it goes right back to auto.Whateva thnx for all the pointers though:thumbdwn:

I have the same problem, i find in the BIOS to get the FSB 1MHz higher stops it going to auto.