PDA

View Full Version : Drilling hole in a copper heatsink with a dremel


XDanger
02-07-10, 04:55 PM
I bought an enzotech mosfet heatsink but its not compatible with my motherboard so I hacked it up so it fits

Now I need to make a hole for the push pin

Will one of those silver colored drill bits do the job?


I dont need the push-pins as I'm using epoxy but it would be good to have em just incase

marqmajere
02-07-10, 07:15 PM
Any steel drill bit will work fine.

Redeemed
02-07-10, 08:58 PM
Staple gun.

XDanger
02-08-10, 03:53 AM
Staple gun.

:D

Quick420
02-08-10, 08:05 AM
Or the handymans secret weapon.........duct tape.

XDanger
02-08-10, 08:16 AM
Or the handymans secret weapon.........duct tape.

I might use that to tape it to my leg while I drill the hole.

Smee
02-11-10, 03:59 PM
I might use that to tape it to my leg while I drill the hole.

I tape it to my leg all the time, It makes walking easier.

CaptNKILL
02-11-10, 08:36 PM
I tape it to my leg all the time, It makes walking easier.

Pshh... I just stuff the end of mine in the top of my left sock.