View Full Version : Detonator to Forceware Problem!

01-08-04, 04:23 PM

I have a GeForce3 Ti200 and Detonator 4x.xx on a PIII 700 with XpPro

When i downloaded and installed ForceWare 53.03 from NVIDIA all sorts of problems started to occur.

Windows starts with LOW resolution, and warnings pop up, saying that none of the driver .dlls can load (one warning/.dll).

I had a similar problem and I read somewhere in a forum (i curse myself for not bookmarking it) that it could be because the old Detonator leaves crap behind when you install ForceWare.

Back then I solved the problem by following instructions I found in a forum similar to this, but now I dont remember how I did it, so i NEED HELP!


Thanx/ Gustaf

01-08-04, 04:33 PM
Did you make sure to properly uninstall your previous drivers before updating? If not, search through this forum on how to do it (it's been listed about a million times already).

01-08-04, 08:38 PM
Ok, Ill try that... again... *sigh*

I guess Im lazy, its a lot easier if someone just tells you what to do... :D

Thanks anyway!