PDA

View Full Version : inno3d fx-5700 tv out problem


tymon
08-20-04, 02:36 PM
I have a problem using tv out on my inno3d fx-5700 with clone mode.
When I click clone then apply it defaults back to single view with no tv shown.

I am using an AMD 2600 barton on a Asus A7V600 board, XP Professional SP1,
directx 9.0c and 56.72 drivers. Not using 61.77/76 because farcry shows all graphics as fog coloured. Tested with 53.03 as well with same result.

Emailed Inno3d support and they said drivers. Updated all motherboard drives and bios and problem still remains. Any ideas????