PDA

View Full Version : A few voltage questions on the 6800


H3NPHLO
10-16-04, 06:29 PM
Hi

I want to increase the voltage on my 6800NU card.
But when I edit the "voltage 2" (thrtl. volt) to 1.4V, and when Ive flashed the bios, Rivatuner still says its 1.2V on the "voltage 2" its supposed to be 1.4 on.
How come?

Im using NvFlash 5.08 and Nibitorv 1.7

/H3NPHLO

crainger
10-17-04, 04:10 AM
I don't think you have changed the right voltage, you gotta change the 3D voltage to 1.4

H3NPHLO
10-17-04, 04:15 AM
Yes i did try to increase the right one.
But none of the three voltages increases.
Can anyone tell me how to write the right commands in NvFlash??

Subtestube
10-17-04, 05:38 AM
You could just change all three. If you do it properly using NiBiTor, it'll work fine. Well, assuming you don't damage your card or not have the power to supply it. I'm unsure of the correct NVflash syntax... I think it's -4 -5 -6... but I could be wrong.

Darkoz
10-17-04, 06:08 AM
To flash using nvflash 5.08, all you do is type the following at the A: prompt (assuming you're flashing your own modded bios)......

nvflash bios.rom (where 'bios' is whatever you named your modded bios)

H3NPHLO
10-17-04, 06:11 AM
To flash using nvflash 5.08, all you do is type the following at the A: prompt (assuming you're flashing your own modded bios)......

nvflash bios.rom (where 'bios' is whatever you named your modded bios)

Ive tried nvflash bios.rom.
No voltages changes according to Rivatuner