emit
04-06-03, 04:07 PM
I have a nForce MCP Networking Adapter in my AMD Athlon/hp computer, and i'm trying to run Mandrake 9.0.
The problem i'm having is the same as the one darkmind is having here (http://www.nvnews.net/vbulletin/showthread.php?s=&threadid=4840&highlight=nforce+network) and here (http://www.nvnews.net/vbulletin/showthread.php?s=&threadid=9366&highlight=nforce+network).
eth0 won't come up, and i cannot connect to the LAN.
First i tried the rpm for Mandrake 9.0. it seemed to install fine, but i could not connect to the LAN. Then i followed the very excellent instructions here (http://www.nvnews.net/vbulletin/showthread.php?s=&threadid=9541&highlight=nforce+network).
the make and make install went off without a hitch, but i still cannot bring up eth0. lsmod shows the nvnet module loaded, but with a use count of 0.
Any suggestions? I'm not sure where to go from here.
edit: forgot to add, the command "ifup eth0" fails with error message:
SIOCSIFFLAGS: Resource temporarily unavailable
I'm not sure what this signifies :(
edit2: the first link was broken
The problem i'm having is the same as the one darkmind is having here (http://www.nvnews.net/vbulletin/showthread.php?s=&threadid=4840&highlight=nforce+network) and here (http://www.nvnews.net/vbulletin/showthread.php?s=&threadid=9366&highlight=nforce+network).
eth0 won't come up, and i cannot connect to the LAN.
First i tried the rpm for Mandrake 9.0. it seemed to install fine, but i could not connect to the LAN. Then i followed the very excellent instructions here (http://www.nvnews.net/vbulletin/showthread.php?s=&threadid=9541&highlight=nforce+network).
the make and make install went off without a hitch, but i still cannot bring up eth0. lsmod shows the nvnet module loaded, but with a use count of 0.
Any suggestions? I'm not sure where to go from here.
edit: forgot to add, the command "ifup eth0" fails with error message:
SIOCSIFFLAGS: Resource temporarily unavailable
I'm not sure what this signifies :(
edit2: the first link was broken