nvnet under 2.4.21 and 2.4.22-rc2
OK, i'm using the nForce 1.0-0261 drivers on an Epox 8RDA+ MB for this. The nvnet driver compiles and loads ok under both 2.4.21 and 2.4.22-rc2 however it doesn't work under either.
In 2.4.21 it detects the correct frame type (Ethernet) but its MAC address is 0C:FF:00:00:00:00, and it can't use the network (DHCP or staticly assigned IPs)
Under 2.4.22-RC2 it doesn't know what type of frame is being used and its MAC address is 16 octets long of which there is about 3 octets of non-zero values (I didn't write these down but I can if need be).
Any experiences or ideas? Was there a patch before 2.4.21 to the network driver API or something?
Well since 2.4.22 isnt stable yet, I suggest you send a bugreport to the kernel developers so this issue can be fixed before the kernel goes stable.
OK, its sorted now... though a bug report is still probably a good idea. my eth0 isn't actually my nforce card. I don't know what it is. I turned off all networking modules in the config, but there is still some phantom driver in the kernel.
ie eth1 is my nforce card and it works fine. :)
|All times are GMT -5. The time now is 04:12 PM.|
Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2013, Jelsoft Enterprises Ltd.
Copyright ©1998 - 2013, nV News.