31.23 Ok - 41.91 Bad
I've installed the nv drivers version 31.23 (RPM) on this system:
- Athlon XP 1800+
- Epox mobo w chipset VIA KT266a
- GeForce 3 ti200 (Abit Siluro)
- kernel 2.4.18 (red hat 7.3)
- Xfree 4.0.2
they work very well.
when I try to install the new version 41.91 (I'm sure I've downloaded the right RPMs) X server started hanging on startup returning the error:
-no displays found-
So I had to come back to the older drivers (now they are working well as before).
It's very strange that a new version doesn't work when the old works perfectly.
Anyone has an idea?
thanks for help.
Can you post your /var/log/XFree86.0.log from a run with 1.0-4191? "No Screens Found" is a very generic error message, and tells nothing out of context.
Are you making sure the kernel module is removed before installing 1.0-4191?
re to re
thanks for help
now i can't post my log for some logistics problems :)
i'm sure i removed the old kernel version.
in the xfreelog there is a warning:
- the chipset "GeForce3 Ti 200" in the video device is not supported by drivers.-
and the error is:
- no display devices found -(only this!!)
Can you post the output of 'lspci -vvv'? Specifically, i'm interested to see the part about your video card.
this is the output of lspci
01:00.0 VGA compatible controller: nVidia Corporation NV20 [GeForce3 Ti200] (rev a3) (prog-if 00 [VGA])
Subsystem: ABIT Computer Corp.: Unknown device 610f
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Step ping- SERR- FastB2B-
Status: Cap+ 66Mhz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort - <MAbort- >SERR- <PERR-
Latency: 248 (1250ns min, 250ns max)
Interrupt: pin A routed to IRQ 11
Region 0: Memory at e0000000 (32-bit, non-prefetchable) [size=16M]
Region 1: Memory at d8000000 (32-bit, prefetchable) [size=64M]
Region 2: Memory at dc000000 (32-bit, prefetchable) [size=512K]
Expansion ROM at <unassigned> [disabled] [size=64K]
Capabilities:  Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot -,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
Capabilities:  AGP version 2.0
Status: RQ=31 SBA- 64bit- FW- Rate=x1,x2
Command: RQ=31 SBA- AGP+ 64bit- FW- Rate=<none>
Make sure you're loading nvidia as the module name instead of NVdriver. As root, type modprobe nvidia and see if it loads.
|All times are GMT -5. The time now is 07:21 PM.|
Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Copyright ©1998 - 2014, nV News.