rh 7.3 and tnt2 problems
have a Diamond Media V770 TNT2 board (32M RAM) I downloaded and ran NVchooser.sh and this told me to install
(I have a dual Pentium-III system)
I modified /etc/X11/XF86Config-4 as suggested and ran startx
X failed to start,
(EE) NVIDIA(0): Failed to initialize the NVdriver kernel module!
lsmod shows that NVdriver is installed and running,
I then tried the src rpms and built/installed those (strangely created i386 files and not i686 files I was expecting), anyway same result - failed to initialize
any suggestions how to get this loaded, I have 2 PC's with TNT boards and it sure would be nice to play quake 3
thanks for your help
Check your linux logfile (for example /var/log/messages) for errors.
found my own solution - not mentioned in FAQ
When the NVdriver starts up it may spit out a message to a console. This could tell you to 'Assign IRQ to VGA in your BIOS'
do this and all will be well
whooo now for quake3
|All times are GMT -5. The time now is 03:57 PM.|
Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ©1998 - 2014, nV News.