Thread: Custom Modeline
View Single Post
Old 04-27-03, 09:21 AM   #4
Registered User
Join Date: Sep 2002
Posts: 2,262

The problem is that none of the possible modes are actually valid. They're either outside the VertRefresh range, or outside the HorizSync range.

This might be because both of those ranges are being adjusted based on EDID information; if this EDID information is incorrect (check your monitor's manual), then use Option "IgnoreEDIDs" (and make sure that you raise your VertRefresh -- having a maximum of 60Hz is very likely WAY too low).
Registered Linux User #219692
bwkaz is offline   Reply With Quote