View Single Post
Old 03-12-07, 09:00 AM   #1
Protex
Registered User
 
Join Date: Apr 2004
Posts: 3
Default 8x card stuck in 4x mode?

I'm unsure if I'm using agp 4x or agp 8x.

Code:
bash-3.1$ cat /proc/driver/nvidia/agp/card
Fast Writes:     Supported
SBA:             Supported
AGP Rates:       8x 4x
Registers:       0xff000e1b:0x1f004312
bash-3.1$ cat /proc/driver/nvidia/agp/host-bridge
Host Bridge:     PCI device 10de:00d1 (nVidia Corporation)
Fast Writes:     Supported
SBA:             Supported
AGP Rates:       8x 4x
Registers:       0x1f00421b:0x00000312
bash-3.1$ cat /proc/driver/nvidia/agp/status
Status:          Enabled
Driver:          AGPGART
AGP Rate:        8x
Fast Writes:     Enabled
SBA:             Enabled
However, if i check my dmesg i get

Code:
AGP: Found AGPv3 capable device at 0:0:0
AGP: Found AGPv3 capable device at 2:0:0
AGP: Enough AGPv3 devices found, setting up...
AGP: Setting up AGPv3 capable device at 0:0:0
AGP: Putting device into 4x mode
AGP: Setting up AGPv3 capable device at 2:0:0
AGP: Putting device into 4x mode
Using slackware 11, 2.4.33 kernel, 1.0-9755 drivers, 6800GS, nforce3 board
Protex is offline   Reply With Quote