View Single Post
Old 05-13-03, 12:19 PM   #3
filiga
FX 5700
 
Join Date: May 2003
Posts: 8
Angry

Still no OpenGL...

The driver README says that the driver should default to AGP 2x since I have K7V motherboard. This did not happen, the driver was using AGP 4x by default. I then modified the kernel module according to the README, recompiled it and got the driver to use AGP 2x. Unfortunately this did not help.

Then I disabled the whole AGP. This did not help either :-| The box still locks when I run any OpenGL app. Two bad, I'd like to do some Cg-programming with the board.

Do I have defective hardware or is the 5200 just too new to function properly??
filiga is offline   Reply With Quote