View Single Post
Old 04-06-07, 05:40 PM   #4
911medic
Is it football season yet
 
911medic's Avatar
 
Join Date: Jun 2004
Location: Near Minneapolis, MN
Posts: 715
Default Re: Overclocking Help

Quote:
Originally Posted by buffbiff21
Honestly, if you have asked around Tech Repository, Tony should be able to aide you through this better than me.

However, I can say that it looks like your CPU is maxed out. The e4300s that I have seen have not been OCing as well as the old e6300s, and not even the new lower-end model Conroes (e6300 & 6400) have been clocking as high. My guess is Kentsfield binning.

Also, I dont think you need to adjust chipset voltage. P5B easily goes above 450; mid 300s should be incredibily easy. vdimm should, also, only help when you reach higher bus speeds. (the 2.1 limit should not hinder your achieving of 400+ fsb)

freecableguy and Tony are the ones to ask though
Thanks for the reply. I haven't asked around there, but have read some very helpful/informative threads over there.

I'm thinking you're right about my CPU. I have never run into one that responds so minimally to vCore. I mean, 10MHz FSB is all I get by really pushing the vCore. I was hoping it was something else.

I didn't think I was pushing either the memory or chipsets' limits at these speeds, but again, I was hoping for a solution other than "CPU at its limits."

Again, thanks for your opinion.
__________________
E4300 @ 3GHz (lapped) || Tuniq Tower 120 (lapped) || Gigabyte EP45-UD3L || eVGA 8800GTS 640MB @ 648/1512/999 || 6GB DDR2-800 @ 5-5-5-15|| 74GB Raptor || 80GB Caviar || 250GB WD || Corsair HX520W || Samsung 225BW 22" LCD (1680x1050) || X-Fi XtremeGamer || Win7 RC x64 || Antec SX1040BII Server Tower || Altec-Lansing ATP3 Speakers
No comprehension to fail; I vacuum the wind for my sail
Can't be the rest; Let others waste my time?
Owning success is the bottom line

911medic is offline   Reply With Quote