DVI doesn't work
I just bought a DVI cable, so I can move the vga one to another computer. I have a CRT IBM p260, but when I have only DVI cable, there is no picture (I rebooted pc). Monitor is also set to input 2 (input 1 is vga).
I reattached vga cable (both cables were attached), so I executed nvidia settings, clicked detect display, and it was correctly recognised! However when I enable it (clone mode), there is no picture when switching to input 2!
I also tried other alignements (right of, left of, bottom....) nothing seems to work.
What could be the problem?
EDIT: Cable is a 5 metre DVI-D
Last edited by kriko; 05-31-11 at 02:34 PM.