Originally Posted by CaptNKILL
Running at 450x8 again. With the ram set to 900. Latencies and voltage set to what OCZ recommends (5-5-5-15 and 2.3V). CPUZ still shows the latencies to be off a bit (5-6-6-17) but its not a big deal.
CPU vcore is set to 1.506 in the bios. Under load it's sitting around 1.44.
Been running Orthos blend for a half hour now. CPU temp is fluctuating between 55C and 59C. Not bad considering it's really damn hot in my room.
When I have more time I might try flipping my fans around a bit to get some fresh outside air straight into my CPU heatsink. Not sure what it'll do, but it wouldn't be too hard to try.
Heh, somehow my HSF came loose apparently and when i booted a few minutes ago my motherboard was at 65C and the e6750 was at 87C in the bios
remounted and temps of the motherboard are now at 35C and the proc is in the 40's. That was pretty fricken scary
I think my CPU is getting some decent cooling (still on stock HSF, will switch it this weekend). I have the TriCool sucking in air at the front, and instead of putting the Thermaltake PCI slot cooler by the GPU, i put it on the side of the hard drive cage, so it moves the air thats getting pulled in, to the CPU and GPU area. I like the layout of this mobo, you dont have to have fans spread out all over the place.