View Single Post
Old 06-04-03, 11:01 AM   #1
bytemare
Registered User
 
Join Date: Jun 2003
Posts: 3
Default possible to enable udma133?

I have an Aopen ak79D-1394, running redhat 9 with kernel 2.4.20. I got everything working, but my IDE shows only udma100 but the board and the hard drive both support 133. Is there anyway to get 133?

I checked the kernel source code and it looks like there's only support for 100... is there a patch?


boot up info:
Jun 2 14:04:11 localhost kernel: Uniform Multi-Platform E-IDE driver Revision:
7.00beta3-.2.4
Jun 2 14:04:11 localhost kernel: ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
Jun 2 14:04:11 localhost kernel: NFORCE2: IDE controller at PCI slot 00:09.0
Jun 2 14:04:11 localhost kernel: NFORCE2: chipset revision 162
Jun 2 14:04:11 localhost kernel: NFORCE2: not 100%% native mode: will probe irqs later
Jun 2 14:04:11 localhost kernel: AMD_IDE: Bios didn't set cable bits corectly.
Enabling workaround.
Jun 2 14:04:11 localhost kernel: AMD_IDE: Bios didn't set cable bits corectly.
Enabling workaround.
Jun 2 14:04:11 localhost kernel: AMD_IDE: PCI device 10de:0065 (nVidia Corporation) (rev a2) UDMA100 controller on pci00:09.0
Jun 2 14:04:11 localhost kernel: ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hdaMA, hdbMA
Jun 2 14:04:11 localhost kernel: ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdcMA, hddMA
Jun 2 14:04:11 localhost kernel: hda: Maxtor 6Y200P0, ATA DISK drive
bytemare is offline   Reply With Quote