nforce driver, mandrake 9.1 and mouse
This sounds like a problem with the usb modules not being loaded. My friend's Leadtek NForce2 board required that we load usb-ohci.o twice, and then I *think* usb-ehci.o (or something similar).
So, do a:
cat /proc/pci |less
Look for your usb controllers on it.
Look for the usb modules, and then use insmod and modprobe on them appropriately until you get it to work. Your usb mouse should be capable of working, unless there is hardware strangeness here of which I am unaware.
We were using Mdk 9.1 as well.
What specific board are you using? If you want, I can probably cobble together more specific directions.
james at geanoverseas dot com
Last edited by angusmash; 06-10-03 at 03:35 PM.