View Single Post
Old 10-29-07, 01:39 PM   #6
DiscipleDOC
 
DiscipleDOC's Avatar
 
Join Date: Dec 2002
Location: Alabama, Planet Earth
Posts: 5,993
Default Re: Help me with the Striker Extreme Overclock

Quote:
Originally Posted by LORD-eX-Bu
I'd help but I am using a different 680i mobo

don't set your cpu v higher than 1.5, try setting it to 1.4 volts and your FSB to 1.2 or 1.3..

don't know what your memory is rated at so would leave that default, go into the bios under cpu options I guess and set the fsb and mem ratio to linked and synced... try to up the fsb little by little until you find a spot that is unstable and then go back and adjust some of the voltages to see if you can get anymore out of it..

I don't know anything about your bios but it shouldn't be too hard to figure out...

is your q6600 a G0? you should check out http://www.xtremesystems.com/forums

they have a good intel overclocking database that goes by motherboard and cpu... lists cpu voltage and different things that could help you out.
Yes...my CPU is a G0.

Also, you said set the cpu v to 1.4 volts......is that my vcore, or should my vcore be set to something else?
DiscipleDOC is offline   Reply With Quote