Folks, I have a new MSI KT4-Ultra BSR mother board with a Promise Serial ATA raid controller built in, which also has an ide connector too! Now folks, i have heard the benifits of raid 0 and would like to try but, not on the entire capacity of the 2 disks I would however, like to try RAID 0 on partitions of my HDDs. Now I've read the manual and I am none the wiser on how to make RAID arrays on 2 HDD partitions. I have made partition at exactly the same spots on both HDD, ie cylinder, head, capacity etc. Does anyone know if this is possible with the promise RAID controllers? I know u can do that through dynamic disks in Win2k and winXP but I would like to do it through the Promise Controller? Help appreciated thanks!!
__________________I5email@example.comGHz - MSI Z77A-GD65 - 4GB X2 A-DATA DDR3 1600 - Corsair H100 - Antec Quatro 850W
Gigabyte Windforce X3 GTX 680 OC - Dell 24" IPS
Intel 320 300 GB SSD - 1 TB Hitachi HDD - 2x 250 GB WD HDD
Corsair K90 - Corsair Venegance 2000 Headset - Razer Naga Epic
Corsair 600T Case