View Single Post
Old 04-08-10, 09:36 AM   #18
Xevious
Registered User
 
Join Date: Aug 2002
Posts: 291
Default Re: Quadview possibe? (Quadro NVS 420)

Quote:
Originally Posted by JaXXoN View Post
I had a similar problem: with the default EDID settings, the TH2G splits the BIOS/post
screen to the three attached LCDs, so that each LCDs shows 1/3 of the screen.
Means: the output was pretty distorted. The solution was to delete the wide screen
EDID and just keep the single LCD EDID flashed (i.e. 1680x1050 for me). This way
the signal is only generated on one output (which in your case should be 1920x1200
scaled up, I assume).
Do you mean add a mode that is just a single monitor? I don't really get how deleting the wide screen edid mode is going to help me here as I am widescreen.


Quote:
Originally Posted by JaXXoN View Post
Plus you could now use eye-candy like compiz if you like :-)

regards

Bernhard
I already was (beryl/XGL) but what going this route did was give me a better refresh rate (Before I was just running it off two DVI inputs and thus only got a bit over 30 Hz before).
Xevious is offline   Reply With Quote