Originally Posted by mojoman0
took the drive out and tried to correct the threads with a screw. the screws went in fine. The pegs still dont want to slide into the hole....how tight of a fit is it supposed to be? Should i be able to push the pegs in as far as i want? because I can't
edit: finally got it in right. Just had to push those pegs in and out really hard a few times and they went in farther. It prolly smashed the threads a bit but that doesn't really matter if I'm not using them anyways.
That sounds about like the issue I had with them - stubborn little bastids sometimes. I'd bet if you had to use screws at any point those threads would clean right up for you.
Glad you got it.