View Single Post
Old 02-04-04, 05:59 PM   #10
learninglinux
Registered User
 
Join Date: Dec 2003
Posts: 8
Default save change to XF86config in vi

Hello dns,

Just type ":wq", then press the enter key.
1) ":" is for changing to command mode from insert mode.
2) "w" is for write (means updating/saving) your current file.
3) "q" is for quitting the vi editor.

If you just want to save without leaving vi, then just
type ":w".

Regards,
learninglinux
(a linux newbie)
learninglinux is offline   Reply With Quote