View Single Post
Old 04-06-05, 11:10 AM   #2
chunkey
#!/?*
 
Join Date: Oct 2004
Posts: 662
Default Re: dualhead settings fedora core 3

Quote:
Originally Posted by jaxxx
1. the resolution of the SGI is wrong, nothing I've tried lets me set the correct resolution (1600x1024). I have tried to use the display applet in the systems menu to set it to the listed SGI/1600SW monitor, but the screen goes into a loop on shutdown, and then a hard reset causes it to revert to a crt monitor.
sound like you "must" use a custom modeline... so add this little piece of "code" into "Section" "Monitor" of your SGI...
Code:
  
# 1600x1024 @ 60.00 Hz (GTF) hsync: 63.60 kHz; pclk: 136.36 MHz
  Modeline "1600x1024"  136.36  1600 1704 1872 2144  1024 1025 1028 1060 -HSync +Vsync
and don't forget to change HorizSync to something like 31.5 - 65.0...

Quote:
Originally Posted by jaxxx
2. The SGI is positioned to the left of the CRT, but linux acts like it's the other way round; i haven't found a way to change it
this should "theoretically" work(couldn't test it... my old monitor died)

Code:
	Screen      0  "Screen0"
	Screen      1  "Screen1" LeftOf "Screen0"
chunkey is offline   Reply With Quote