View Single Post
Old 11-28-05, 02:19 PM   #5
zarin
Registered User
 
Join Date: Mar 2003
Location: Ontario Canada
Posts: 7
Send a message via ICQ to zarin Send a message via AIM to zarin Send a message via MSN to zarin Send a message via Yahoo to zarin
Default Re: Loss of working TwinView (CRT/TV) after upgrade?

Ok - here we go. I used the ConnectedMonitor string because without it the card does not detect the TV as connected. If I roll back to the older drive,r it all works again. I had edited out the modes and default depth etc trying to get the new driver working - I reverted the config.....

I started X with the old driver, and original config, ad it worked fine, including TV (bug log attached). I upgraded the driver, and tried to start X - would not start - no useable screens. (Log also attached) I then removed the connectedmonitor string, and tried to load X gain - it loaded, but did not detect the TV, thus, there is no picture there. (Log for this also attached)

As for starting X with the command, yes, I used
startx -- -logverbose 5
for all attempts.

Thanks so much for the help! If I have to, I will revert to the older driver, but, the fact that it used to work, and does not now bothers me somewhat.

. Robert
Attached Files
File Type: txt nvidia-bug-report.7167.txt (97.8 KB, 126 views)
File Type: txt nvidia-bug-report.7676.txt (74.2 KB, 107 views)
File Type: txt nvidia-bug-report.7676-new.txt (90.1 KB, 131 views)
zarin is offline   Reply With Quote