View Single Post
Old 08-13-06, 10:20 AM   #4
shadog1962
Registered User
 
Join Date: Aug 2006
Posts: 3
Default Re: Can't change resolution after NV driver 8762

Quote:
Originally Posted by netllama

You didn't say how you were trying to change modes, however if the display is reporting that nothing other than 1280x1024 works, then that isn't a driver problem, its a display problem.

It would be worthwhile to remove all the modelines in your xorg.conf, as they shouldn't normally be needed, and could potentially be incorrect.

Thanks,
Lonni
Thanks for your reply. It doesn't matter how I try to change resolution. Right on desktop or through SAX2 the results are the same. I did check the monitor setup via the hardware info and all the resolutions seem to be available. I will try your suggestion on the modelines.

Thanks Randy
shadog1962 is offline   Reply With Quote