|12-31-08, 09:01 AM||#1|
Join Date: Dec 2008
NVIDIA Driver not getting right mode over HDMI
I have a problem that seems fairly common. The nvidia driver (180.18) isn't calculating the right mode from my TV's (Dell 32" LCD) EDID. It ends up sending the TV a signal that can't be displayed. If I turn off use of EDID freqs, I get better results, but the chosen mode still isn't "right".
If I use the VESA driver instead, it gets it right every time and chooses my desired resolution of 1280x720.
Is there a way I can figure out what the VESA driver has detected and hand craft a modeline to use with the nvidia driver? I know when I crank up X's logging I get lots of information about the TV's timing, etc.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Need Help Installing NVIDIA Tesla M2070Q in Linux RHEL5||Ferianto85||NVIDIA Linux||0||05-18-12 08:35 PM|
|Getting the proprietary nvidia driver to run with Debian 3.0 r0 (woody)||Katchina404||NVIDIA Linux||9||01-12-03 08:49 AM|
|nvidia + 2.4.19 gentoo = messed up||ulukay||NVIDIA Linux||18||11-01-02 11:58 PM|
|Error messages... HELP!!!!||Imperito||NVIDIA Linux||3||09-24-02 10:46 PM|
|nVidia drivers + Red Hat Linux 7.3||Error404||NVIDIA Linux||17||08-16-02 11:34 AM|