|12-28-03, 04:03 AM||#1|
Join Date: Dec 2003
Location: South Africa
GForce4 MX440 SE with Linux
I am running a P4 2.4, 256 MB RAM, with Slackware 9.0
I have a gforce 4 mx440 se, and downloaded the drivers for linux, so i would be able to use it effectavely. I managed to compile it for my kernel(2.4.20) fine. When I try to use it, X starts, and the nvidia logo comes up, and then the system hangs!!!!
the only time I ever get any info in my X Log files, is when i set logverbose to 5. The problem is also that the Log files, and normally my config file comes out very garbled when I reset my PC.
When I start up my PC it tells me that I have the gforce 4 MX440 SE, but when I run lspci it reports a gforce MX440. Could this be the problem, if so how do I force the module to use the SE files rather than the standard ones??
Thanks a lot
|Thread||Thread Starter||Forum||Replies||Last Post|
|295.59 (long-lived branch release) for Linux x86/x86_64 released||AaronP||NVIDIA Linux||0||06-13-12 03:38 PM|
|295.59 (long-lived branch release) for Linux x86/x86_64 released||artem||NVIDIA Linux||0||06-11-12 12:25 PM|
|nVidia Linux drivers with Linux on Mac, help?||Thetargos||NVIDIA Linux||0||05-13-12 01:52 PM|
|Mandrake Linux 9.0 (Dolphin) now available | comments?||volt||General Linux||10||10-19-02 11:13 PM|
|Linux VS. Windows XP! XP wins!||dostler||NVIDIA Linux||20||09-15-02 04:47 PM|