|09-05-08, 05:25 AM||#1|
Join Date: Sep 2008
FX-5200 driver always uses wrong refresh rate after reboot.
This week I installed a new driver, which I downloaded from the Nvidia website.
I can use the new driver to enable my CRT monitor to use a higher refresh rate, 100 Hz, which is good. But it fails to correctly install this new refresh rate in the X Server configuration file.
After I reboot, the refresh rate is 60 Hz, which flickers terribly!
It has apparently managed to modify the X Server configuration file, because 60 Hz is different from the 85 Hz that I was getting before I installed the driver, but it has done so incorrectly.
So every time I boot into Linux, I have to open the to "Nnvidia X Server Settings", and set the refresh rate to a higher refresh rate.
What can I do about this, to get it to use 100 Hz after a reboot?
Do I have to edit the "xorg.conf" file to get it to start with the correct refresh rate?
I am using Kubuntu 8.04.1, with a GeForce FX-5200 graphics card. The driver I installed is version "173.14.12". I'm using a Sony GDM-F520 monitor, which I run at 1600 * 1200.
Last edited by kubuntuuser; 09-05-08 at 05:36 AM. Reason: I made a mistake in the subject heading. Corrected now.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Gnome3 with composite is very slow on Geforce FX 5200 with 173.14.31 driver||Artox||NVIDIA Linux||0||05-26-12 10:33 AM|
|New 40.41 refresh rate fix ????||Smokey||NVIDIA Windows Graphics Drivers||8||08-30-02 01:32 PM|
|Refresh rate fix for opengl?||Zarich||NVIDIA Windows Graphics Drivers||1||08-29-02 02:47 PM|
|Refresh rate not fixed in SP3||Creole||Microsoft Windows XP And Vista||2||08-03-02 11:32 AM|
|Multi monitor refresh rate problem||ascully||General Hardware||6||07-31-02 02:56 PM|