Go Back   nV News Forums > Linux Support Forums > NVIDIA Linux

Newegg Daily Deals

Reply
 
Thread Tools
Old 07-08-10, 07:29 AM   #1
openelec.tv
Registered User
 
Join Date: Dec 2009
Posts: 8
Question activate and setup framebuffer after loading kernel

Hi,

is it possible to activate and setup (configure) an framebuffer device after loading kernel (without dealing with kernel command line parameters)?

I need this, because i am provide images for my small embedded distribution with included intel/ati/nvidia graphic drivers. the right driver to load Xorg will be loaded from Xorg - this works very good. But i need an framebuffer based splash screen at boot. With KMS i dont have problems to show the splash on ATI/Intel graphic based Hardware. Only with the NVIDIA driver i must set vga= parameters to the kernel in the bootloader config. I want that the Users must not setup the bootloader, so i need an solution to activate and setup Framebuffer from userspace (before the splash starts) to the right resolution for any TV.

is there an way? (AFAIK the nouveau KMS drivers dont works with nvidias binary graphic drivers :-( )
__________________
greetings, Stephan

✩✩✩✩✩ OpenELEC.tv ✩✩✩✩✩
✩✩✩✩✩ try now the fast booting and smallest (50-70MB) embedded XBMC distribution with PVR function ✩✩✩✩✩
openelec.tv is offline   Reply With Quote
Reply


Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -5. The time now is 09:00 AM.


Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright 1998 - 2014, nV News.