12-28-03, 03:03 AM
|
#1 | |
|
Registered User
Join Date: Dec 2003
Location: South Africa
Posts: 1
|
GForce4 MX440 SE with Linux
Hi there.
I am running a P4 2.4, 256 MB RAM, with Slackware 9.0 I have a gforce 4 mx440 se, and downloaded the drivers for linux, so i would be able to use it effectavely. I managed to compile it for my kernel(2.4.20) fine. When I try to use it, X starts, and the nvidia logo comes up, and then the system hangs!!!! the only time I ever get any info in my X Log files, is when i set logverbose to 5. The problem is also that the Log files, and normally my config file comes out very garbled when I reset my PC. When I start up my PC it tells me that I have the gforce 4 MX440 SE, but when I run lspci it reports a gforce MX440. Could this be the problem, if so how do I force the module to use the SE files rather than the standard ones?? Thanks a lot |
|
|
|
|
12-28-03, 10:42 AM
|
#2 | |
|
Registered User
Join Date: Dec 2003
Posts: 11
|
what is the chipset of your motherboard ?
what lspci report about your AGP ? unknow device ? |
|
|
|
|
 |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 295.59 (long-lived branch release) for Linux x86/x86_64 released | AaronP | NVIDIA Linux | 0 | 06-13-12 02:38 PM |
| 295.59 (long-lived branch release) for Linux x86/x86_64 released | artem | NVIDIA Linux | 0 | 06-11-12 11:25 AM |
| nVidia Linux drivers with Linux on Mac, help? | Thetargos | NVIDIA Linux | 0 | 05-13-12 12:52 PM |
| Mandrake Linux 9.0 (Dolphin) now available | comments? | volt | General Linux | 10 | 10-19-02 10:13 PM |
| Linux VS. Windows XP! XP wins! | dostler | NVIDIA Linux | 20 | 09-15-02 03:47 PM |
