8762 ddc does not work

[promeneur]

MDV 2006, kernel 2.6.12
Xorg 6.9
driver nvidia 8178 installed with
- nvidia-installer : no success
- dkms with MDV 2006 rpm from PLF depository : no success

driver nv(xorg driver) : ddc works well
driver 8178 : ddc works well
driver 8762 :
- ddc does not work (nvidia does not get any data from the monitor)
- does not aware of my modeline in "Section Monitor"

i tried to use the option [Option "UseEDID" "yes"] but no success

i had to replace [Virtual 800 600] by [Modes "800x600nvi"] to use my modeline according to start X and kdm with success

when you see the Xorg log there is nothing about any i2c module or ddc module

[netllama]

Please generate and post an nvidia-bug-report.log.

Thanks,
Lonni

[promeneur]

Sorry i joined a filed but i did not see that did not work.
i try again.

[netllama]

The attached bug report shows you requesting and getting the "800x600@72nvi" modeline in your X configuration. I'll need to see a bug report which illustrates the problem you're reporting.

Thanks,
Lonni

[promeneur]

sorry i am a bit inattentive see the good bug report addendum: when executing startx you have the nvidia error: nvidia (0) failure to construct a valid mode list

[netllama]

This is a Mandrake issue, and has been discussed in other threads. You need to either increase the Virtual size, or explicitly request a Mode instead of the Virtual.

-Lonni