NVS 285 Quadro Graphics card + intel 915GM

[nav_nv]

Hi

I am using Intel 915GM chipset and trying to get three displays, two from the NVIDIA PCI card and one from the onboard intel graphics chip.

I disabled the PCI compliance mode from 1.0a to 1.00, and was able to see both the intel display controller and NVS Quadro controller. The only problem is that with this BIOS setting when I use my xorg.conf that I used with PCI NVS 280 and I am getting only black screen on all the three displays. When I remove the PCI-Ex card I get my on board display. Any help here would be helpful.

Thanks
Regards

[nav_nv]

Any help regarding my post please